Bradford White | Sealed Combustion

40-Gallon Natural GasPower Direct VentWater Heater

All-in Price @ $3,320 + tax

Dual-pipe sealed combustion at 40-gallon capacity — complete air isolation, ideal for tight or highly efficient homes. Bradford White, 6-yr warranty.

Request More Info or
Submit Question

Complete Combustion Isolation at 40 Gallons

The 40-gallon dual-pipe direct vent system uses one PVC pipe to pull outdoor combustion air directly into the sealed burner chamber, and a second PVC pipe to exhaust combustion gases back to the outside. The water heater's burner operates in complete isolation from your home's indoor air supply. No conditioned indoor air is consumed, and no combustion gases can enter the living space under any operating condition.

This is the most rigorous venting standard available for residential gas water heaters. It satisfies the air supply requirements of tightly constructed homes — including newer builds in Eagle Mountain, Saratoga Springs, Lehi, and other fast-growing Utah communities where construction standards have moved toward much tighter building envelopes. If your home has spray-foam insulation, triple-pane windows, or an ERV/HRV ventilation system, sealed combustion appliances are the appropriate choice.

At 40-gallon capacity, this unit is right-sized for one to three people. Households of four or more in a home requiring sealed combustion should consider the 50-gallon dual-pipe direct vent at $3,420 for more first-hour hot water delivery.

Bradford White Quality in a Direct Vent Configuration

Bradford White's direct vent units use the same Vitraglas enamel tank lining and Dynaclean dip tube found across their residential product line. These features reduce internal corrosion and sediment accumulation — important considerations in Utah's hard-water environment where calcium deposits can shorten tank life in inadequately specified units.

The dual-pipe configuration requires more material and installation time than a single-pipe power vent, which accounts for the higher price point. Both PVC pipes penetrate the exterior wall — typically through a rim joist in basement installations — and terminate with weatherproof caps that prevent wind intrusion and pest entry. Our technicians seal all wall penetrations with fire-rated caulk and test airflow balance before commissioning.

Our all-in price of $3,320 + tax includes the Bradford White unit, licensed Utah plumber installation, expansion tank, drain pan, stainless flex connections, all PVC piping for both intake and exhaust runs including exterior termination caps, seismic straps, and haul-away.

Comparing Your 40-Gallon Gas Venting Options

Utah homeowners needing a 40-gallon gas unit without chimney access have three venting paths. The atmospheric vent standard unit at $1,860 uses a metal flue through the roof or sidewall — simple and least expensive, but requires an available flue. The single-pipe power vent at $2,850 adds an electric blower to force exhaust through a single PVC pipe, allowing horizontal routing but still using indoor combustion air. The dual-pipe direct vent at $3,320 is the sealed option — fully isolated combustion for homes where indoor air use is a concern or code requirement. Our technicians will help you identify which option fits your home's specific configuration.

40-Gallon Dual-Pipe Direct Vent: Technical Snapshot

UnitBradford White 40-Gallon Gas Power Direct Vent
VentingDual-pipe PVC — sealed combustion, no indoor air consumed
Burner input~40,000 BTU/hr
First-hour delivery~60–70 gallons (Bradford White PDV series)
Warranty6 years tank & parts, 1 year labor
Pipe materialSchedule 40 PVC for both intake and exhaust runs
TerminationDual exterior caps — weather-sealed and pest-resistant
Expansion tankIncluded in all-in price
Seismic strapsIncluded — required by Utah code
All-in price$3,320 + tax

When Utah Building Code Requires Sealed Combustion

Utah adopted the 2021 International Residential Code (IRC), which includes Section G2407 on combustion air requirements. In homes built to modern energy codes — particularly those with spray-foam insulation, continuous vapor barriers, or mechanical ventilation systems — the natural air infiltration that older atmospherically-vented appliances relied on is no longer available. Inspectors in Salt Lake, Utah, and Davis County increasingly require sealed combustion appliances in new construction and permitted remodels that tighten the building envelope.

If your home was built after approximately 2015 in a Utah subdivision, or if you've had an energy audit that identified very low air changes per hour (ACH), the dual-pipe direct vent configuration may be your only code-compliant option for a gas water heater. Our technicians will confirm this before installation — we do not install equipment that would fail a permit inspection.

40-Gallon vs. 50-Gallon Dual-Pipe: Which Size Is Right?

Both the 40-gallon and 50-gallon Bradford White dual-pipe direct vent units use identical sealed combustion technology. The decision comes down to household size and peak demand, not venting preference.

40-Gallon Dual-Pipe at $3,320

  • ✓ 1–3 person household
  • ✓ One bathroom in regular use
  • ✓ Smaller utility room footprint
  • ✓ ADU or accessory unit with limited space
  • ✓ Tightly sealed home requiring sealed combustion

50-Gallon Dual-Pipe at $3,420

  • ✓ 3–5 person household
  • ✓ Two or more bathrooms in regular use
  • ✓ Teenagers with long shower habits
  • ✓ Soaking tub that draws heavily on hot water
  • ✓ Tightly sealed home with larger hot water demand

The $100 price difference between 40-gallon ($3,320) and 50-gallon ($3,420) reflects only the unit cost differential — installation complexity is identical for both sizes.

40-Gallon Power Direct Vent: Common Questions

What makes dual-pipe direct vent different from single-pipe power vent?

A single-pipe power vent uses an electric blower to push exhaust gases outside through one PVC pipe — but the burner still draws combustion air from inside your home. A dual-pipe direct vent adds a second pipe that pulls outdoor air directly into the sealed burner chamber, so the unit operates in complete isolation from your indoor air. No conditioned air is consumed, and no combustion gases can back-draft into the living space.

Do both PVC pipes go through the same exterior wall penetration?

Yes. In most installations, both the intake and exhaust pipes penetrate the exterior wall within a few inches of each other — typically through a rim joist on basement installations or a framed wall opening in utility closets. Our technicians core both holes, install the Bradford White termination caps, and seal all penetrations with fire-rated caulk before commissioning.

Is a permit required for dual-pipe direct vent installation in Utah?

A plumbing permit is required in most Utah jurisdictions for water heater replacement. If the city requires a permit, we can assist the homeowner in applying for the permit and coordinating with the city. If an inspection is required post-installation, we can help coordinate that as well. The quoted prices typically do not include the cost of a permit.

Can the 40-gallon dual-pipe unit be installed in a closet or tight utility space?

Yes. The sealed combustion design means no combustion air louvers or clearance to combustible materials for air intake is required — the unit draws all combustion air through the sealed intake pipe. Minimum clearances to the unit itself still apply per the Bradford White installation manual, but the dual-pipe design eliminates the combustion air clearance requirements that atmospheric units need.

How long does installation take?

Most 40-gallon dual-pipe direct vent installations run 3 to 4 hours. Drain, disconnect, and removal of the old unit takes roughly 45 minutes. New unit set, water connections, gas connection, and PVC pipe runs for both intake and exhaust typically take 2 to 2.5 hours. Final pressure test, flush, and cleanup round out the visit. We take the old unit with us.

Everything Included.
No Surprises.

Our all-in price covers 100% of what you need, nothing added at the door.

New Brand-Named Water Heaters

Brand-new unit, not refurbished

Professional Installation

Licensed & insured technicians

Expansion Tank

Required by code, always included

Drain Pan

Protects your floor from leaks

Upgraded Connections

Flexible corrugated stainless lines

Venting Upgrade to Code

Proper venting for safety & efficiency

Earthquake Straps

Utah code-compliant seismic straps

Old Unit Haul-Away

We remove your old water heater

All Parts & Labor

Zero additional charges, ever

Request More Info

Call us at (801) 997-1986 or fill out the form below and we'll reach out shortly.

Or call us directly: (801) 997-1986